Livestock fence panels with barbed wire demarcating properties contain livestock and provide privacy. The economical choice about is the one that provides two to four rows of barbed wire, depending on the desired purpose, connected to the same distance of the wooden or metal poles. These fences with wires need support to keep the weight of the posts and and wire tension. Wear thick gloves when working with barbed wire to prevent injuries. Wanted, Connected to the same distance of wood or metal posts. These fences with wires need support to keep the weight of the posts and and wire tension. Wear thick gloves when working with barbed wire to prevent injuries.
Dig a hole in the ground, from 0.60 to 0.90 cm, which will put the livestock fence panels for the fence. Pour cement and a wheelbarrow and add water until consistency to work. Place a wooden pole in the corner hole and pour a few centimeters of cement. Make sure the post was leveled and upright.
12 Photos Gallery of: Innovative Ideal Livestock Fence Panels
Dig a hole for the support post to 2.44 m from the corner post in the same direction but outside the fence line. Place the pole to support the hole and repeat the process for cementing it.directionbut outside the fence line. Place the pole to support the hole and repeat the process for cementing it. Measure 20 cm below the livestock fence panels and make a hollow hole toward the support post. With the hammer, insert a pin-lock in the hole, leaving 5 cm show. Drill another hole in the hollow support post in a parallel point to pin-lock the corner post. Place the ferrule in barbed wire. Place the winch on the support post and firm the ratchet on the hook the winch livestock fence panels. Hammer the wire in the support pole with staples. Once set, remove the winch tension and remove the ratchet. Repeat the process of fixing the wire lines on metal poles using clips.